Ask Irwin

I am crosscutting oak veneer plywood on a table saw, and the veneer is chipping on the backside. What type of blade would you recommend to cleanly cut across plywood?

A 10", 80T blade with a reduced feed rate would be your best bet. The IRWIN Marathon #14076 would be a good choice.

Ask Irwin a QuestionClick a question below to view the answer.

Chisels

Circular Saw Blades

Drill Bits

Extractors

Fastener Drives

Hand Saws

Hole Saws

Levels

Marking Chalk

Pliers and Adjustable Wrenches

Snips

Tape Measures

Taps, Dies, & Sets

Utility Knives & Blades

Laser Guide

Door Lock Installation Kit

STRAIT-LINE LL 120

STRAIT-LINE Rolling Tape

STRAITLINE® Sonic Laser Tape 50

STRAITLINE Stud Finder 150 LCD (Wall Scanner)

STRAIT-LINE Intersect w/Stud Finder

STRAITLINE Intersect

STRAITLINE X3

IRWIN Lettered and Numbered Drill Bits

IRWIN Permanent Staining Chalk